Hello Everybody,

can anyone please help with a full list of snapshot and video stream url.

I updated to version 26.31.3.225 and the stream urls do not work anymore.

I also would like to know if the resolution of the videostream and the snapshot could be changed.

Thank you for your support.

Hi sir,
Have you enabled the rtsp on the device web(Login to the web and go to the Intercom->RTSP->RTSP Basic to configure)?
The video stream URL is: rtsp://device_ip/live/ch00_0
You can check the real-time picture via URL: http://device_ip:8080/picture.jpg
Yes, you can change the resolution of the video on the web. Login to the web and go to the Intercom->RTSP to configure.
Thanks.

Hi Evelyn,

thank you for your response. I the earlier firmware versions there was also a mjpeg stream availiable http://device_ip/video.mjpeg

I used this stream for our homeautomation system. Is there a new stream url for the mjpeg stream?

Thank you!

Hi,
The MJPEG stream is also: rtsp://device_ip/live/ch00_0
In addition, you need to go to the Intercom->RTSP->RTSP Stream on the web to configure the video codec as the MJPEG(as shown in the picture).

I use http://ip-adress:8080/video.cgi for the stream.

By the way which homeautomation system are you using. I think you are from German too?

Regards
Holger

holgerwolf wrote:I use http://ip-adress:8080/video.cgi for the stream.

By the way which homeautomation system are you using. I think you are from German too?

Regards
Holger

Hi,
Yes, the URL is correct. Can you use this to not display the images?
In general, if the homeautomation system supports MJPEG, it works fine.
Thanks.

Hello All,

I tested the url stated before... http://ip-adress:8080/video.cgi

It is working, but the resolution is only 640 x 480. No matter what the Rtps Settings are.

In earlier firmware versions it was possible to make a higher resolution by using the following url:

http://ip-address:8080/video.mjpeg?resolution=1280x720

Could you please specify which setting affect the resolution for this url... http://ip-adress:8080/video.cgi


Thank you for your support!

Hi Sir,

Please upgrade to our latest firmware, and then go to the path "Intercom-Advanced."

There is an option named MJPEG Service, you can configure the video resolution here for the url.

Best Regards.

Hi Jon,

could you please give me a link to the latest firmware?

Thank you

andre1979 wrote:Hi Jon,

could you please give me a link to the latest firmware?

Thank you

Hi sir,

You can go to our forum-cloud to download the latest firmware.
Here is the link viewtopic.php?f=31&t=207

Best regards.